796LSC

796lsc

Line Shaft Driven Curve Module

SPECIFICATIONS
TREAD ROLLERS: 2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T. DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive. DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft, located on inside radius. NOTE: Spools are keyed to provide positive drive (designed not to slip on drive shaft). COUPLINGS: Couplings located both ends (type "A") or one end only (type "B" or "C"). See 'line shaft curve couplings' and specify. TANGENTS: 1'-0" both ends on 60° and 90°; 1'-6" both ends on 30° and 45°. 1'-0" infeed, 1'-0" discharge and no center tangent on 180°. Tangent roller centers 3" RC.		BEARINGS: Precision, lubricated, ball bearing units with steel housings. 6 per 90° and 60° curve; 4 per 45° and 30°. UNIVERSAL JOINTS: 4 per 90° and 60° curve; 2 per 45° and 30° curve. FLOOR SUPPORTS: Optional BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. MOTOR DRIVE: Driven by 796LS.

24 Hour Shipments
Include 30°, 45°, 60° And 90° Modules