| 196VP | |
| Medium Duty Variable Pressure Live Roller Accumulator | |
 |
Download Hi-Res Tech Drawings (pdf format)
|
| SPECIFICATIONS | ||
| TREAD ROLLERS:
1.9" dia. x 16 ga. steel, model 196S. PRESSURE ROLLERS: 1.9" dia. x 16 ga. steel, model 196S. RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable. BELTING: 2-1/4" wide "high strength" PVC-150 belt. *NOTE: WHEN SLAVE DRIVING OTHER UNITS, OPTIONAL 6" WIDE PVC-120 DRIVE BELT MUST BE USED ON UNITS 20' LONG AND ABOVE. CENTER DRIVE: Reversible drive with 24" integral belt take-up. For units under 8'-0" overall length, drive components must be stacked. Consult factory for minimum unit elevation. END PULLEY: 4" dia., crowned, with 1-3/16" dia. shaft. DRIVE PULLEY: *4"
dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged. |
BED: 7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in
conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports. SQUARING RODS: Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'. BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings. FLOOR SUPPORTS: Optional MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor. ROLLER CHAIN: Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base. ELECTRICAL CONTROLS: Optional |
|
|
24 Hour
Shipments Include All 1-Foot Increments 6'- 0" TO 100'- 0" |
 Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above. |