196LRCS

Medium Duty Belt Driven Live Roller Curve Spur

SPECIFICATIONS
TREAD ROLLERS: 2-1/2" dia. to 1-11/16" dia. x 14 ga. tapered rollers (model 254T); 1.9" dia. x 16 ga. (model 196S) straight tangent rollers. PRESSURE SHEAVES: Provides drive belt pressure to upper tread rollers. BELT: "B" section V-belt. TAKE-UP: Screw type adjustable sheave with flat idler sheaves provided to maintain belt tension. TANGENTS: 12" opposite spur end on 60/30 unit; 18" opposite spur end on 45/45 unit. BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. FLOOR SUPPORTS: Optional		MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed. SPUR HAND/DRIVE LOCATION: Drive located on outside of curve. Specify hand of spur as "left hand" or "right hand" and location of drive specified as "left hand drive" or "right hand drive". NOTE: Drive location determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location. BELT SPEED: 60 FPM, constant. ROLLER CHAIN: Drive shaft is driven by No. 50 chain. CAPACITY: 500 lb. total distributed live load. ELECTRICAL CONTROLS: Optional

24 Hour Shipments
Include 45/45° & 60/30° Curve Spurs

NOTE: This unit is not recommended for accumulating loads.