196LRC                                                             BACK TO GP PAGES

 
  Medium Duty Belt Driven Live Roller Curve

 

  

Download Hi-Res Tech Drawings (pdf format)

  SPECIFICATIONS
TREAD ROLLERS:  2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T; 1.9" dia. x 16 ga. steel straight 
tangent rollers, model 196S.

PRESSURE SHEAVES:  Provides drive belt 
pressure to upper tread rollers.

BELT:  "B" section V-belt.

TAKE-UP:  Screw type adjustable sheaves provided to maintain belt tension.

TANGENTS:  1'-0" both ends on 90°; 
1'-6" both ends on 45°; 1'-0" both ends on 180°. Tangent roller centers provided on 3" RC.

SPEED:  60 FPM, constant.

BED:  7" x 1-1/2" x 12 ga. formed steel channel frame. 

BEARINGS:  End shafts are supported 
by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

FLOOR SUPPORTS:  Optional

ROLLER CHAIN:  Drive shaft is driven 
by No. 50 chain.

DRIVE LOCATION:  Drive located on 
outside of curve. Specify left hand 
tangent length, right hand tangent length and drive location ("left hand drive" or "right hand drive"). NOTE: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

CAPACITY:  500 lb. total distributed 
live load.

MOTOR DRIVE:  1/3 HP, 230/460/3, 
60 cycle, ODP right angle gear motor, located at infeed end of curve below bed on 45° and 90° curves; 3/4 HP supplied on all 180° curves.

SPECIAL WIDTHS:  Consult factory for pricing of ALL widths not shown.

ELECTRICAL CONTROLS:  Optional
 
  24 HOUR SHIPMENT
Include 45°, 90° And 180° Curves
NOTE:  This unit is not recommended for accumulating loads.