196LR 
Medium Duty Belt Driven Live Roller

 

Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

SPECIFICATIONS
TREAD ROLLERS:  1.9" dia. x 16 ga. steel, model 196S.
 
PRESSURE ROLLERS:  1.9" dia. x 16 ga. steel, model 196S.

BELTING:  6" wide black PVC-120 COS. 

CENTER DRIVE:  Reversible drive with 24" integral belt take-up. Specify location.

DRIVE PULLEY:  4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.

END PULLEY:  4" dia., crowned, with 
1-3/16" dia. shaft.

RETURN ROLLERS:  1.9" dia. x 16 ga. steel, model 196S, adjustable.

BEARINGS:  All pulley bearings are
precision, heavy duty, lubricated, ball bearing units with cast iron housings.

SPEED:  60 FPM, constant.		 BED:  7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

SQUARING RODS:  Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

FLOOR SUPPORTS:  SM-6 adjustable 
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

MOTOR DRIVE:  1/3 HP, 230/460/3,
60 cycle, ODP right angle gear motor.

ROLLER CHAIN:  Drive pulley is driven 
by No. 50 chain for 1-1/2 HP or less 
and No. 60 chain on larger drives. Chain take-up provided on motor base.

ELECTRICAL CONTROLS:  Optional
24 Hour Shipments 
Include All 1-Foot Increments 
6'- 0" TO 100'- 0"
Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above.