End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. Flush Grid Curve Conveyors.

Roach Conveyors

The 24 Hour Shipment Leader
Tel: (870) 483-7631

Plastic Belt Flush Grid Curve Conveyor

Roach Conveyors

700 Flush grid

plastic belt

Curve conveyor

700PBC Conveyor

SPECIFICATIONS

BELTING: Series 2200 flush grid gray curved polypropylene belt, FDA & USDA approved belting.

DRIVE SPROCKETS: 5.3" pitch dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5" or 2.5" square bore.

TAIL SPROCKETS: 5.3" pitch dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5" or 2.5" square bore.

END DRIVE: Allows one-direction operation ONLY; this conveyor is NOT reversible.

BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

BED: 7" x 1-1/2" x 10 ga. formed steel channel frame with UHWW wearstrips attached to bed and belt return pan.

TAKE-UP: Catenary type located at discharge end.

MINIMUM RADIUS: 2.2 x belt width, measured from inside edge of belt.

TANGENTS: Minimum length is 1.5 x belt width located at each end of conveyor; minimum of 3' at discharge end required with 5' recommended. Optional additional tangent may be located at discharge end.

BELT SPEED: 60 FPM, constant.

FLOOR SUPPORT: Optional.

DIRECTION OF FLOW: Specify right hand or left hand.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor on 45 degree and 90 degree curves; 3/4 HP supplied on all 180 degree curves.

ROLLER CHAIN: Drive shaft is driven by No. 50 chain.

ELECTRICAL CONTROLS: Optional